MAKING A MURPHY SLING

(Inspired by Eddies Wheels)

Mike Aitken
The finished item:
murpheyssling1



Materials Required:
·    Approx 4 feet of 1 inch diameter rubber hose
·    Adhesive suitable for bonding rubber
·    Duct Tape
·    Approx 5 feet of rope / weight bearing tape

 
Step1:
murpheyssling2


Figure out how long the two pieces of rubber hose need to be.  The length of these will be determined by the size of your dog.  If you have an Eddies Wheels, you have the perfect template to determine the correct length.


Step 2:
murpheyssling3



Cut the correct length of rubber hose.  Add a couple of inches to each length to allow for a join, and slice a couple of inches of one end as shown below.  Glue the joint, and wrap with Duct Tape for strength.


Step 3:
murpheyssling4



Using a sharp knife, cut a  2 – 3 inch oval piece of rubber from one of the loops you’ve made:


Step 4
murpheyssling5




Bring the two loops together and glue them as below:


Step 5:
murpheyssling6




Add Duct Tape:


Step 6:
 Add weight-bearing rope / tape
    Add your dog




reprinted with kind permission from Mike Aitken
chloebutton   talabutton

 
The above information is simply informational. It's intent is not to replace the advice of a veterinarian nor to assist you in making a diagnosis of your pet. Please consult with your own veterinarian for confirmation of any diagnosis. Your pets life may depend on it.